Synthetic Oils for Metal Working

Wilube Chemical Inc. products in the synthetic oil category include:

WILUBE 655

Wilube 655 is a synthetic fluid with exceptional hard water stability and low foam characteristics. This product is designed to be used for machining and grinding applications. 655's buffered pH provides excellent stability over wide dilution ratios resulting in high operator acceptance. 655 is formulated to inhibit corrosion when diluted to 30:1. This product can be used on carbon steel, stainless steel, and other alloys.

WILUBE 9090

Wilube 9090 is a chlorinated synthetic heavy-duty drawing and stamping fluid. 9090 contains inhibitors to deter the formation of corrosion on the finished part. This product may be used as received or diluted with water. Recommended dilution range is 100% concentrate for severe applications to a 7% solution for light work. 9090 exhibits low foaming characteristics and is easily cleaned in aqueous cleaning systems. The outstanding physical characteristics of this product coupled with the cost/performance function ratio justify looking at replacing your present machining coolant.

WILUBE AF-12

Fin Stamping Lubricant AF-12 represents a new chemistry in the selection of commercially available fin stamping lubricants. AF-12 is a water-based synthetic lubricant designed for aluminum fin stamping.

 

WILUBE HFL-30FX

Fin Stamping Lubricant HFL-30FX is an aluminum and copper fin stamping lubricant. This product may be used on both "draw" and "drawless" fin dies. HFL-30FX is formulated to improve fin wettability characteristics. THis product has less than 1% VOC content.

WILUBE 605

Wilube 605 represents a new line of commercially available synthetic machining coolants. Wilube 605 has superior cooling and wetting properties
that produces excellent tool life and surface finish. Wilube 605 has an excellent extreme pressure additive package which allows for machining of ferrous and non-ferrous metals. This product has a long sump life and is very efficient at rejecting tramp oil. Typical use dilutions are 3% to 10% depending on the severity of the application. The outstanding physical characteristics of this product coupled with the cost /performance function ratio justify looking at replacing your present machining fluid.